
The sensor is designed to measure linear movement, e.g. the stabilizer bar movement. The electronic is designed with a stainless steel magnetic shaft with Hall element. The Hall element is disposed between two magnets in association with a movable specially formed ferromagnetic part. This is used to control flux in the sensor in order to produce a linearly varying output voltage dependent on the position.
The main benefit of this sensor is its contactless Hall effect technology and its robust design for motorsport applications.
Features
- Application: 0 to 100 mm
- Housing: Aluminum
- Weight w/o wire: 35 g
- Technology: Hall contactless
- Output signal: 0.025 to 4.975 V
Application
Application |
Up to 100 mm |
Operating temperature range |
-40 to 125°C |
Max. vibration |
Vibration Profile 1 (see www.bosch-motorsport.com) |
Technical Specifications
Mechanical Data
Weight |
35 g |
Protection class |
IP68 & IP69K |
Mounting |
2 x M4 |
Shaft bearing life |
25 million cycles |
Housing |
Aluminum sulphur anodised |
Shaft |
Stainless steel 303 |
Electrical Data
Power supply US |
5 V ± 0.25 V |
Current IS, during power on settlement |
< 100 mA |
Current IS, normal operation |
< 45 mA |
Resolution |
0.025 % of measurement range |
Characteristic
Temperature coefficient |
< ± 0.003 % FS/°C |
Sensitivity tolerance |
< ± 2.5 % FS |
Non-Linearity |
< ± 0.5 % FS |

Connectors and Wires
Connector |
ASU 6-03-03 PA-HE |
Connector loom ASU 0-03-03SA |
F 02U 000 194-01 |
Pin 1 |
Power 5 V |
Pin 2 |
Ground |
Pin 3 |
Signal 0.05 to 4.95 V |
Sleeve |
FDR-25 |
Wire size |
AWG 26 |
Wire length L |
15 to 50 cm |
Various motorsport and automotive connectors on request. | |
Please specify the requested wire length with your order. |
Installation Notes
The sensor can be connected directly to most control units. |
The sensor is designed with contactless Hall effect technology. |
Each mounting orientation is possible. |
The sensor is also ferromagnetic sensitive. Please make sure the mounting material is not ferromagnetism. This can lead to inaccurate measurement. |
Safety Note
The sensor is not intended to be used for safety related applications without appropriate measures for signal validation in the application system. |
Ordering Information
Linear Position Sensor LP 100-H
Order number: F 02U V02 061-01